+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Firmware History (https://www.comfortforums.com/forum-60.html)
+---- Forum: Comfort Firmware (https://www.comfortforums.com/forum-79.html)
+---- Thread: UCM # 1 scanned as HDL (/thread-3741.html)
- ident - 03-18-2014
We have found the cause of a strange bug where Scanning of Modules by Comfigurator detects UCM #1 as HDL, instead of General
This only happens after doing a sync of Keypad words on any LCD keypad KP04, KP04, KP06 using the keys *1 pressed together.
The workaround is to reset Comfort.
This happens up to Comfort firmware 7.050
This will be fixed in the next Comfort firmware 7.057