+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Firmware Upgrading Problems (https://www.comfortforums.com/forum-111.html)
+---- Thread: No keypad (/thread-3817.html)
- fpicard102 - 05-22-2014
Hi,
Is it possible to upgrade comfort firmware (when UCM/Ethernet firmware is version 6), if I don\'t have keypad? Effectively I can\'t press F 0 (actually I use iPhone or Ipad to arm and disarm)
Regards
- ident - 05-23-2014
Look for the Response \"Engineer Code enable\" and press Execute
This is the response activated by the F0 key
- fpicard102 - 05-23-2014
Hi,
All my firmware are upgraded.
Thank you for reactivity and quality of your support
Regards