+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Zwave (https://www.comfortforums.com/forum-62.html)
+--- Thread: Fibaro Smoke Sensor FGSS-001 (/thread-4439.html)
- MDKKEN - 04-18-2016
Hi,
I have the wired version of Fibaro Smoke Sensor FGSS-001 that is wired to comfort.
This device supports Multilevel Sensor V1. I thought \"sensor\" would be available in register type drop down. In mine I only have flag and counter.
I have latest firmware for ZWave and Comfort. Also latest version of configurator 3.11.1.0.
Am I mistaken? I use VERA Edge as the primary controller.
- yuanchang - 04-19-2016
Hi MDKKEN,
There are two solutions for this Fibaro Smoke Sensor FGSS-001\'s usage:
First solution is to include this device into Z-wave network and use the UCM/Zwave learn from the primary controller. After that, map the device with any counter in comfigurator. Under corresponding counter response, program alarm trigger if the counter change to a certain value.
Second solution is to connect the smoke sensor to any input of comfort directly and set the corresponding zone type as \"Fire NC\".