+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: KNX (EIB) (https://www.comfortforums.com/forum-12.html)
+---- Forum: KNX Support (https://www.comfortforums.com/forum-112.html)
+---- Thread: UCM2 is not a UCM/KNX2 (/thread-4658.html)
- davidsilva - 03-14-2017
Hi,
Recently, I had some problems with UCM/KNX or UCM/KNX2.
When I try write to EEPROM, I have a error: \"UCM 2 is not a UCM/KNX2\". And when I try a second time I have a diferent error: \"Error writing configurator\".
If I try Read from EEPROM, I can but is isn\'t the configuration what I want.
How can I solve this problem?
Best regards,
Thanks.
- slychiu - 03-14-2017
First do a reset of Comfort and see if the problem still exitis
if so, then do Scan for Modules again and clock Copy to Clipboard below comfigurayro main window
Paste to a text file and send to support@cytech.biz
- davidsilva - 03-14-2017
Hi,
Now I\'m testing with other Comfort II Ultra and other keypad but the same UCM/KNX2, and the problem still exist. I will sent for your email.
Thanks.
- slychiu - 03-16-2017
Hi David
The General UCM used for Programming firmware is only 5.192
see attached screenshot
It needs to be upgraded to the latest version 7
However for version 5 UCM firmware you need to have another UCM to upgrade this ucm using the UCM programming cable
see http://www.comfortforums.com/forum4/1782.html
When it has been upgraded to UCM firmware version 7, then this UCM can be used to upgrade Comfort ansd the UCM/KNX2 without the programming cable, just use Comfigurator
If you do not have another UCM/USB or ETH03 perhaps you can borrow a UCM or ask Vestereme to to the upgrade for you
By the way you cannot paste an image onto a post in the forum, it will not accept it and will display garbage
- davidsilva - 03-17-2017
Hi,
I already upgrade UCM firmware, and now I can write to EEPROM UCM/KNX2.
Thanks for your help.
- slychiu - 03-18-2017
This advise is now in a new topic
http://www.comfortforums.com/view_topic.php?id=4660&forum_id=73