Low level audio output instead of speaker level for alarm - Printable Version +- Comfort Automation/ Security System Forums (https://www.comfortforums.com) +-- Forum: Support (https://www.comfortforums.com/forum-2.html) +--- Forum: Questions on Installation and Connection (https://www.comfortforums.com/forum-123.html) +--- Thread: Low level audio output instead of speaker level for alarm (/thread-5212.html)

- freak69 - 08-27-2020 Hi, Just checking, is there any way I can tap off a low level audio output from the PCB? The current audio output for alarms is amplified and ideally I\'d like to tap off an RCA level feed that I can mix with others before piping to a set of ceiling speakers. (Ideally I\'d like to avoid a conversion high level to low level and tap off the main board)Same question from a slave board which happens to be nearer...  Thanks!  - slychiu - 08-29-2020 If you mean the Siren Output, no, this is a square wave signal and there is no  low levekl audio output However you can use the AUD01 audio output submodule which plugs ito a UCM/USB or UCM/ETH03  This has a phone jack which you can connect to an amplifier and has a cvolume adjustmentThe output from the AUD01 will be keypad speaker output, ie you will hear the keypad siren sounds and announcements lie a normal speakersee manual attached