Comfort Automation/ Security System Forums
Z-Wwave door switch as an alarm zone - Printable Version

+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Zwave (https://www.comfortforums.com/forum-62.html)
+--- Thread: Z-Wwave door switch as an alarm zone (/thread-5290.html)

- 111rdw - 02-24-2021

I\'m trying to avoid running a wire to a door by using a Z-Wave door switch. I cannot understand after many readings of the manual and forum posts how (if it is even possible) how to do this. I can see the switch in the z-wave mapping but then it all gets a bit confusing to me - I\'m an amateur at this. If this is possible what do I need to do? thanks in advance

- slychiu - 02-25-2021

First you have to Create a Virtual Node in UCM/Zwave so that the zwave door switch can send comands to it.  There is a button to Create viertual Node. Then associate the virtual Node to the door switch which should be a ruting slave. 

Next you can map the virtual Node to a Virtual INput in Comfort. A virtual Input is an unused input in Comfort which acts like a real input but is triggered by an external device like Zwave. 

This allows zwave door switch to act like a real input. Thew releavent sections in the UCM/Zwave manual describe each of these steps


- 111rdw - 02-25-2021

Thanks. All sounds very simple now you have explained it. I’ll give that a try.

- 111rdw - 02-25-2021

Taken me most of the day but it\'s working. My first mistake was trying to link the virtual and real nodes in comfort instead of my Fibaro HC2. And I could not get associations to work. However works fine using a scene to link them.

- theshepherdmatt - 06-17-2021

I\'m really struggling with my Virtual inputs and responses. When I try to assign a virtual input on/off in Responses it wont let me select a different zone? It seems fixed on a single zone?

- slychiu - 06-18-2021

For virtual zone onoff you should  only be able to select zones that are Virtual, ie mapped to zwave as viertual zones. You are not able to select non-virtual zones


- theshepherdmatt - 07-15-2021

thanks for the reply, I have the virtual input working perfectly on zone 17 but configurator won\'t let me create another virtual input with zone 18? 
cheersmatt

- slychiu - 07-16-2021

Quote:First you have to Create a Virtual Node in UCM/Zwave so that the zwave door switch can send comands to it. There is a button to Create viertual Node. Then associate the virtual Node to the door switch which should be a ruting slave.
Quote:Next you can map the virtual Node to a Virtual INput in Comfort. A virtual Input is an unused input in Comfort which acts like a real input but is triggered by an external device like Zwave.
Please check that you have followed the above instructions to create a Virtual zone with zone 18