+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Zwave (https://www.comfortforums.com/forum-62.html)
+--- Thread: Communication error between UCM baseboard and Z-wave sub-module (/thread-5367.html)
- Ian - 02-25-2022
I have added a couple of z-wave window sensors to my z-wave network. I want to add them to comfort as part of the alarm system.I did the usual \'learn\' procedure and after a couple of attempts it started to learn. Then Comfigurator stopped learning and the primary controller showed an error message.I tried again but nothing is happenning.Now I see an error in red in the bottom left of the Comfiguratot window; Communication error between UCM baseboard and Z-wave sub-module.I have restarted both Comfort and the primary controller (HomeSeer)
Any suggestions of what may be wrong?Comfort 2 UltraZ-wave module
- Ian - 02-25-2022
OK - I powered down then up the UCM and it now seems to be talking to the z-wave again!
- slychiu - 02-26-2022
Zwave is a bit flaky sometimes. I am glad you got it working