+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Software Applications (https://www.comfortforums.com/forum-4.html)
+--- Forum: WizComfort (https://www.comfortforums.com/forum-21.html)
+--- Thread: No Sound on PC with WizComfort! (/thread-614.html)
- namnp - 05-14-2007
I can arm/ disarm with WizComfort/Keypad and voice on external power speaker is OK (via Line Out 3mm jack). Just there is no sound on built-in PC/ Speaker & Mic (via Out+GND UCX PCB\' terminal to Mic input of PC);
UCX 5.92 (with Audio); Comfort firmware 5.45; WizComfort version 1.4.6.
What shall I need to check?
Thanks
Even I can see the command from Comfort to PC as SM000040, SM000140, SM000000 after the command ... as below within Comfort monitor
I?0101
PS00
SM000040
SM000140
MD025A
AM095A
KL01000000
AL130000BF025A
KL01000000
SM000000
- Guest - 05-15-2007
Could you have forgotten to enable the microphone settings on your PC\'s volume control? Does a normal microphone work correctly when it is plugged into the PC\'s mic input?
- namnp - 05-15-2007
System sound now finally via UCX, even not as loud and clear as I expected with keypad ! It may need to improve connecting wires externally, I suppose and would do it to see how much better sound can get.
(And also better result when using UCX\' Voice out 3.5mm jack with external power speaker - not the Line OUT terminal to notebook\' Mic input!)
Thanks