Comfort Automation/ Security System Forums › Support › Comfort as Fire Alarm
Smoke detector

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Smoke detector
david8811 Offline
Junior Member
**
Posts: 30
Threads: 5
Joined: Aug 2018
Reputation: 0
#10
08-20-2018, 01:35 AM (This post was last modified: 08-20-2018, 01:36 AM by david8811.)
Gentlemen, thank you for your support. I decided to wire it with 2 EOL resistors and it works perfectly. However, one end of 2.7k resistor and the COM cable joint is “hanging” with no additional termination point to attach to because there are only 4 termination points for this type of smoke detector. I may have to add an additional termination point on the detector cover to secure the joint.
Find
Reply


Messages In This Thread
[No subject] - by - 08-17-2018, 04:33 AM
[No subject] - by - 08-17-2018, 07:22 AM
[No subject] - by - 08-17-2018, 01:46 PM
[No subject] - by - 08-18-2018, 02:10 AM
[No subject] - by - 08-18-2018, 02:32 AM
[No subject] - by - 08-18-2018, 02:41 AM
[No subject] - by - 08-18-2018, 02:54 AM
[No subject] - by - 08-18-2018, 05:10 AM
[No subject] - by - 08-18-2018, 10:13 AM
[No subject] - by - 08-20-2018, 01:35 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)