Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hoping for some inspiration from someone with a good memory
#5
Thanks Chiu.  I have just tried another upload to double check - the names mostly seem to be very accurate.  Has it perhaps worked out the Zone Names from the Phrases?  Something isn\'t quite right with the vocabulary though - we don\'t have a \"Maid\" or \"Children\".  I have attached an \"after\" image.

Something else I have noticed this morning.  Comfort announced that it was opening the curtains.  The action immediately after that should be that it opens a blind - triggered by a pulse of channel 25 which is on a LEM in the expansion cabinet .  What actually happened was that a light was switched on - which can only have happened via the CBUS UCM.
I don\'t know whether that gives any more clues, but it sounds like that there is some kind of mismatch between the hardware and the programming.
I also noticed while looking around in Comfigurator (remember 2.2.3) that where we had a phase of \"all\" and \"rooms\" in the Control Menu, it now has \"\" and \"room\" - again suggesting a vocabulary issue.  I wonder whether the Comfigurator version which I used years ago, but lost and replaced with one downloaded a few months back, had an updated vocabulary or something.
Any more clues very welcome.
Thanks,
Nick



Attached Files Thumbnail(s)
   
Reply


Messages In This Thread
[No subject] - by - 12-17-2021, 04:37 PM
[No subject] - by - 12-17-2021, 05:37 PM
[No subject] - by - 12-17-2021, 06:51 PM
[No subject] - by - 12-18-2021, 01:50 AM
[No subject] - by - 12-18-2021, 09:18 AM
[No subject] - by - 12-19-2021, 02:49 AM
[No subject] - by - 12-19-2021, 09:31 AM
[No subject] - by - 12-20-2021, 01:37 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)