UCM ETH Failing to connect

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Options

UCM ETH Failing to connect

ident Offline

Administrator

Posts: 3,493
Threads: 476
Reputation: 0

#11

04-16-2012, 01:51 PM

This appears to be the same problem as just reported in http://www.comfortforums.com/forum73/2830.html

Your UCM is the same as Pgordons ie ETH01 is plugged on top of an old UCM05
The J2 shunt must be connected to the \"RS485\"side. It could have fallen off while you were \"tidying up\" I would bet 10 Euros on that!

Find

« Next Oldest

Next Newest »

Messages In This Thread

[No subject] - by - 04-15-2012, 10:11 PM

[No subject] - by - 04-15-2012, 10:19 PM

[No subject] - by - 04-15-2012, 10:21 PM

[No subject] - by - 04-15-2012, 10:29 PM

[No subject] - by - 04-15-2012, 10:33 PM

[No subject] - by - 04-15-2012, 10:36 PM

[No subject] - by - 04-16-2012, 01:13 AM

[No subject] - by - 04-16-2012, 06:53 AM

[No subject] - by - 04-16-2012, 01:40 PM

[No subject] - by - 04-16-2012, 01:51 PM

[No subject] - by - 04-16-2012, 02:02 PM

[No subject] - by - 04-16-2012, 02:09 PM

[No subject] - by - 04-16-2012, 02:11 PM

[No subject] - by - 04-16-2012, 02:19 PM

[No subject] - by - 04-16-2012, 02:20 PM

[No subject] - by - 04-16-2012, 02:40 PM

[No subject] - by - 04-16-2012, 06:17 PM

[No subject] - by - 04-16-2012, 07:54 PM

[No subject] - by - 04-17-2012, 01:58 AM

[No subject] - by - 04-17-2012, 07:16 AM

Forum Jump:

Users browsing this thread:

3 Guest(s)