05-16-2013, 10:02 PM
I upgraded firmware 6.020 to 7.027 today.
Subsequently after arming the system to away mode, and then disarming the system, I encountered a problem with a response which had previously been working fine.
On entry to the house while in \"away mode\" a zone response (the entry route) switches an output to \"flash\" (connected to a buzzer). When the system is disarmed, the Miscellaneous Event \"Security Off Response\" has a response which switches that output to \"off\". That worked with 6.020. With 7.027 the output remains in \"flash\" and is not switched off.
As a temporary work around I have included in the Miscellaneous Event \"Security Off Response\" response an \"all outputs off\", and that silences the buzzer. Obviously this is not a solution. I wonder has this something to do with the new feature \"Output command ON or OFF is ignored if the output state is unchanged\" when the command has previousy been \"Flash\"?
Subsequently after arming the system to away mode, and then disarming the system, I encountered a problem with a response which had previously been working fine.
On entry to the house while in \"away mode\" a zone response (the entry route) switches an output to \"flash\" (connected to a buzzer). When the system is disarmed, the Miscellaneous Event \"Security Off Response\" has a response which switches that output to \"off\". That worked with 6.020. With 7.027 the output remains in \"flash\" and is not switched off.
As a temporary work around I have included in the Miscellaneous Event \"Security Off Response\" response an \"all outputs off\", and that silences the buzzer. Obviously this is not a solution. I wonder has this something to do with the new feature \"Output command ON or OFF is ignored if the output state is unchanged\" when the command has previousy been \"Flash\"?