Delay on RIO input

[scroggyg]

I am configuring a RIO to monitor a RF receiver to open garage doors.

What happens is that the RIO input is closed, ( momentary action for 1 second) and approx 5 seconds later the response is triggered. The response is triggered from the on event.

I also see a similiar behaviour with a PIR on a zone input triggering a light over X10.

I have Ultra II with 7 keypads, 3 voice stations 2 slaves and 1 RIO at present.

Thanks

George

:?

[palmlodge]

Are you using an output pulse on the RIO output ? If so, whats the delay specified as ?

[slychiu]

It should not take 5 seconds
What is your firmware version?
The delay may also be due to your response triggering other things
Can you send the ccl file to support@cytech.biz?