Login

**schford** · (This post was last modified: 10-12-2011, 07:56 AM by schford.)

Oh Dear - I thought it was going too well.

It has completely stopped working this morning when I came down - it wont even do anything in monitor mode now.

I have tried resetting UCM, resetting whole of comfort. I deleted the UCM and typed everything but in but nothing....

I have checked the RAKO 232+ is receiving commands (it is - I did this by connecting it to an RS 232 port on my computer and it both sends and receives command sok)

Any other ideas please? This is so infuriating :-)

**UPDATE** I switched Comfort off and disconnected the battery waited 3 minutes then switched back on and now its working!

Stuart

***slychiu*** · 10-13-2011, 02:03 AM

Always check that the UCM/USB or ethernet is communicating with the PC so that commands can be sent to the UCM/Universal.

Also check that the D9 and D10 red and green leds are blinkng on the Universal, which means that Comfort is communicating with the Universal UCM

If these two conditions are OK then everything should be working