Comfort 1 system advise

[ident]

For Comfigurator 3, go to View > Monitor I/O and check the box
This opens the Monitor IO window which shows what Comfort is doing
In comfigurator 3 you can \"check status\" of zones, outputs, flags, Counters

Check that the time in Comfort is correct


You can check if the LSM01 is giving oN or Off to Comfort

[mccltd]

Hi,

Ident with regards your last post I have downloaded comfigurator 3 and loaded my ccl into it.

When i turn on the monitor i/o I get commands show when things are happening but how do I decipher what they mean?
For example I just triggered my landing infra red and in the monitor it came up
ip0301
xtl1005
xtl0605
ip0300

Also I found the check status flags but the statuses show as unknown.
Does this only work with a comfort 2 panel?

[ident]

IP0301 means Input 3 On
IP0300 means Input 3 Off
XT is an x10 message
you cann refer to the Comfort protocol whichcan be downloaded from https://www.cytech.biz/product_details.php?item_id=269 for details of messages

I am afraid the status flags may not work for Comfort 1

[mccltd]

Thank you ident.

Something in my system is driving me crazy at the moment and I cannot work it out. Especially as I haven\'t changed anything.

Home could you please send me the clean cclx file. I presume I can load it into my comfort 1 system.

Also with this clean file does anything work? Ie once I have put my codes in will it function as an alarm it will it be totally unusable?

[mccltd]

I notice in the upgrade 2 kit that it comes with a UCM/USB can this be upgraded to work on a network as well as i would like to use the iOS integration.

[ident]

You can get an additional ETH03 submodule or to replace the USB. The submodules can be removed and exchanged. The Eth03 will cost more than USB

[mccltd]

hmm can\'t find the eth03 in the Uk.
Would they be able to change the icm/usb in the kit to a ucm/eth3?

[ident]

I suppose so, if you pay for the difference