How to Use Comfigurator
Pages: 1 2
Important Threads
- Comfort Bus Monitor for Troubleshooting (0 Replies)
- View Modes (0 Replies)
- Use of Timers for Delay (0 Replies)
- Use of Counters (2 Replies)
- Sunrise Sunset Times and Daylight saving (0 Replies)
- File Menu (2 Replies)
- Programming with Comfigurator (0 Replies)
- Getting Started with Comfigurator (0 Replies)
- UCM Connection Settings (2 Replies)
- Modules and Settings does not match Modules in Modules Tab (1 Reply)
- How to Convert a Comfort I .ccl file to Comfort II cclx file (0 Replies)
- "General Information" Screen in Comfigurator (0 Replies)
- Vocabulary Upgrading (20 Replies)
Threads
- Upgrading Firmware (5 Replies)
- Help with extracting programming out of the LOGIC ENGINE CONTROLLER PCB (5 Replies)
- Writing to and Reading from Comfort (5 Replies)
- Graphical References in Comfigurator (10 Replies)
- Restoring Old versions of the CCLX file (1 Reply)
- Event log and user sign in designations (2 Replies)
- User Mode in Comfigurator (10 Replies)
- Upgrading Comfigurator and Defaults (1 Reply)
- Scanning for Modules (0 Replies)
- Selective Write (0 Replies)
- ULTRA Main Board FW ver. and Mobile Apps KNX Status Refresh (0 Replies)
Pages: 1 2