FAQs - Technical
Important Threads
- Cytech AI Search (0 Replies)
- Comfort Register Monitor (0 Replies)
- Zone Trouble (1 Reply)
- Comfort CM9000 Technical Specs (1 Reply)
- Reminder Messages in Alarm Dialout (0 Replies)
- Siren/Doorbell Volume on Keypads (0 Replies)
- Common Problems Encountered for newcomers (2 Replies)
- Partitions in Comfort (0 Replies)
- Partitions in Comfort - Case Study (12 Replies)
- Tamper does not sound the External Siren when System is Unset (1 Reply)
- Power Failure and Low Battery Alarms (3 Replies)
- User Codes Lost and Defaults to 1234 (1 Reply)
- Phone Trouble (0 Replies)
- dialing problems (0 Replies)
- Write User Codes to Comfort does not change User Codes (2 Replies)
- How to Reset Lost User Code (0 Replies)
- Getting Started with Comfort (1 Reply)
- Monitor Normally Open and Closed Zone Types (0 Replies)
- How to enable to disable dial-out for Low battery, Power Failure etc (2 Replies)
- KP04 LCD Displays "Press * 1 to Sync"' (0 Replies)
Threads
- VOIP calling using Grandstream HT802 (0 Replies)
- External Power (25 Replies)
- Where are the Infrared Codes .ifr stored? (0 Replies)
- DTMF not detected when dialing out or Dialing in (0 Replies)
- Updated serial protocol document? (2 Replies)
- removed door station. advice please (4 Replies)
- Adding key switch to original Comfort panel (4 Replies)
- Battery question (1 Reply)
- Antenna connection broke (7 Replies)
- New feedback from BT regarding dial tone in UK (4 Replies)
- When does Security Mode change value? (7 Replies)
- Alarm Siren off while dialing to Monitoring Station (1 Reply)
- Change CMS number and CMS account number using Keypad (2 Replies)
- Battery check (11 Replies)
- Date / Time change in Event Log (40 Replies)
- Windows 10 (2 Replies)
- Logging Zone Activations (2 Replies)
- How are Zones (inputs) and Outputs numbered on Comforts, LEMs and Slaves? (1 Reply)
- Upgrading Comfort I to Comfort II - Module Compatibility (1 Reply)
- Where to download Manuals (0 Replies)