Comfort Automation/ Security System Forums

[user=86]ident[/user] wrote:

Quote:When you get the Connecting.. and data error message, can you use DS Manager and see if there is a connection symbol on the UCM/Ethernet as seen in the screenshot with the double arrow? This means that there is a connection active and it will prevent a new connection from being made

Ident,

NB device is 192.169.0.98

When I first opened DS Manager with the app connected, I saw broken red arrows in each direction with the explanation \"serial-to-Ethernet buffer overflow\". I disconnected (closed the app), the red arrows disappeared. I opened the app, the red arrows reappeared. Screen print attached. I have been unable to reproduce this yet.

I therefore rebooted the ETH02 to get a fresh start.

I start with connection closed/device idle on DS Manager. No arrows.

Then I try to connect firstly with WiFi. Normal connection established (blue arrows in each direction). App works okay.

I close completely the app. I wait.

Then I open the app in 3G. I DO NOT select a system.
Yet on DS Manager I get blue arrows in each direction.
The Device is connected.

I select a system, and I get \"data error\" on 3G, on DS Manager blue arrows in each direction.

I wait, and try again, I connect, then \"data error\", then no blue lines on DS Manager.

I try again, this time I connect okay. Again on DS Manager blue lines in both directions.

Update:

After some time connected via wifi with no problems, a connection error happened. Reconnected. Thereafter the DS Manager shows the connection with broken red arrows in each direction with the explanation \"serial-to-Ethernet buffer overflow\".

In DS Manager is this just a record of the last error, or an ongoing error?

Please see possible fix in here http://www.comfortforums.com/forum96/2540.html
This topic will be closed, as it is now more than 3 pages. Any comments please continue there