Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Products > Expansion Modules > Need to remove LEM from main baord - plastic standoffs
Full Version: Need to remove LEM from main baord - plastic standoffs
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

MDKKEN

10-13-2014, 12:42 AM
Hi,

I need to get access to TEL IN, TEL OUT on main board to add the ADSL board, however LEM board with plastic stand offs is in the way. How to undo/remove the plastic stand offs? The metal standoff had screws that you could undo etc? I can not break the standoff?

tech07

10-13-2014, 06:13 AM
You can remove the LEM from the plastic standoffs by squeezing the top until the PCB can come out
Later versions of LEMs come with threaded standoffs

juwi_uk

10-13-2014, 10:23 AM
What I did on mine is to buy some nylon threaded standoffs from Maplins in the UK.  Not sure what length you need but these and then put nut on the end.

http://www.maplin.co.uk/p/maplin-hexagon...pack-qt82d

http://www.maplin.co.uk/p/maplin-hexagon...pack-qt80b

http://www.maplin.co.uk/p/maplin-hexagon...pack-qt78k

Julian
Comfort Automation/ Security System Forums > Products > Expansion Modules > Need to remove LEM from main baord - plastic standoffs