Expansion Modules
Pages: 1 2
Important Threads
- Slave Expansion Module for CM9001 (3 Replies)
- Local Expansion Modules - Zone Numbering (0 Replies)
- Expansion Modules Introduction (1 Reply)
- Automatic Detection of LEM03 in Comfort (1 Reply)
- SEM Firmware Versions (0 Replies)
- LEM Mounting on Comfort PCB (0 Replies)
Threads
- OPO3 and OPO3B what is the difference (1 Reply)
- LEM01 pcb - fitting on top of master CPU or slave pcb (0 Replies)
- comms Problem SEM01 (1 Reply)
- Slave Expansion Modules (3 Replies)
- Wanted - LEM02-M2 or LEM03-M2 (to expand CM9000) (0 Replies)
- LEM01-M2 on SEM01C? (4 Replies)
- SEM Confusion (18 Replies)
- SEP01 - Some simple questions (3 Replies)
- SEM Setup Issues (2 Replies)
- Slave expansion Module 01 + 02 (26 Replies)
- Lem03-M2 and CM9001 (1 Reply)
- Can I have clarification that I can connect a bellbox to an sep module (2 Replies)
- 4th SEP, zones show as virtual inputs. (4 Replies)
- LEM3 appearing in the Comfigurator (1 Reply)
- what is the technical difference between SEM and RIO modules (3 Replies)
- Need to remove LEM from main baord - plastic standoffs (2 Replies)
- SEM IDs (1 Reply)
- Difference between LEM and RIO (4 Replies)
- LEM are connected directly via a Ribbon cable (4 Replies)
- difference between the master unit and Slave uit (2 Replies)
Pages: 1 2