Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Products > Expansion Modules > LEM3 appearing in the Comfigurator
Full Version: LEM3 appearing in the Comfigurator
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

dellboy13

02-21-2015, 07:31 PM
Hi,
Should the LEM3 appear in the configurator under slave modules? I have enabled the \'LEM3 (24 Zone)\' setting and connected the ribbon cable. The system is a Ultra running firmware version 7.065 and the configurator is connected via Ethernet and is V3.9.9.0

Cheers

slychiu

02-22-2015, 08:15 AM
No LEM does not appear in the modules, as it is part of the Comfort.

Only modules connected by the RS485 bus appear in the modules
Comfort Automation/ Security System Forums > Products > Expansion Modules > LEM3 appearing in the Comfigurator