Comfort Automation/ Security System Forums

Hi, Just a few Questions regarding RS232 Comms from UCM to Homevision Pro which I am looking to get working.
1)I presume you don\'t have to be Logged in for the UCM to send out RS232 Data generated from a response?

2) If I use the SR00 Command to turn off Auto Status Reports, will that still allow RS232 Commands to be sent that are generated as part of a response?
3)Once Status Reports are switched off, does a reset re-enable  or do you need to login and Send SR01 to re-enable?

:-for context
 - What I am trying to do as a first stage is get Comfort to Report to Homevision via Serial when a Security Mode Changes. 
Many Thanks
Joules

Quote:1)I presume you don\'t have to be Logged in for the UCM to send out RS232 Data generated from a response?

I assume you are using UCM/232 ie UCM06 + RS232 submodule
You do need to be logged in before you can send or receive any messages

Quote:2) If I use the SR00 Command to turn off Auto Status Reports, will that still allow RS232 Commands to be sent that are generated as part of a response?

auto status report  affect messages from Comfort. You can send messages and get replies but any messages that are generated by Comfort are blocked

Quote: 3)Once Status Reports are switched off, does a reset re-enable or do you need to login and Send SR01 to re-enable?

Reset will re-enable status repports
:-for context
 - What I am trying to do as a first stage is get Comfort to Report to Homevision via Serial when a Security Mode Changes. 
Many Thanks

Thanks for the Reply
Just to clarify:
Is the answer to Question 2 \'Yes\'  - ie Status reports Off does not stop RS232 generated as part of a response?
Many Thanks
Joules

It does not stop send rs232 message action

In principle only broadcasts from Comfort are affected