+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Arming and Disarming (https://www.comfortforums.com/forum-72.html)
+---- Thread: Fail to arm the alarm (/thread-2691.html)
- scyong36 - 01-17-2012
Hi anybody can help.?
when i want to on the alarm but i facing the problem. coming out the word \"nulo\" and fail to turn on the alarm...
my alarm model is \"clipsal mindrepro alarm system\"
please help if anyone know. thank a lot...
- ident - 01-18-2012
First can I ask you not to flood the forum with multiple posts about the same subject as this may annoy members who subscribe to all forums?
One post wil be sufficient as we will be notified about any new messages regardless of which forum it is posted to
What is your Comfort firmware version
You can use Comfigurator and do Transfer > System Information, or if you do not have a UCM, read the label on the Comfort panel U1 IC eg ULT 5.123, OPT 5.200
Is there voice on the keypad at all? eg when you enter the use code and go into user menu do you hear the voice menu? Or you can press F5 to hear the event log? Is there any events announced
If the voice is lost it may have this effect. In this case Upgrade the vocabulary using the UCM and Comfiguratoro 3.4.0, see the instructions at http://www.comfortforums.com/forum76/1623.html and read the section of the UCM manual which gives the instructions
- scyong36 - 01-20-2012
how about if dont have UCM? how i can do program to upgrade ?
- ident - 01-20-2012
Did you answer the question if the system has loft its voice?
If the voice has been lost, It cannot be done by the keypad
Ask your distributor to reload the vocabulary or send it back to Cytech
55 Ubi Avenue 1 #07-04 Singapore 408935