+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Heatmiser (https://www.comfortforums.com/forum-42.html)
+--- Thread: UCM/Heatmiser 7.031 - 7.034 (/thread-3572.html)
- ident - 10-20-2013
UCM/Heatmiser 7.031 has been released. The RS485 interface is supported at present. Support for wifi heatmisers is being tested and will be introduced later
Note that the UCM/Heatmiser does not include Rs485 or Ethernet interface, and must be ordered separartely according to what heatmiser is used, RS485 or Ethernet
The UCM/Heatmiser manual can be downloaded from https://www.cytech.biz/ucmheatmiser_manual.html?category_id=107
- ident - 11-13-2013
UCM/Heatmiser firmware 7.033 has been released
The changes are
- \"Send Date/Time to Heatmiser\" under UCM/Heatmiser Properties is now working. This allows date and time to sync to Heatmiser
- Reading/writing for Frost Protect Temperature, Set Room Temperature and Thermostat are working
- Reading of Frost Protect Status, Built-in Temperature, Current Heating State, and Current Hot Water are working
- ident - 12-14-2013
Heatmiser 7.034 (Beta) fixes some problems with Data error and conflicts for RS485 and wifi heatmisers
Those who have reported problems with heatmiser 7.033 please upgrade and test if the problems are fixed