UCM/Heatmiser 7.031 - 7.034

[ident]

UCM/Heatmiser 7.031 has been released. The RS485 interface is supported at present. Support for wifi heatmisers is being tested and will be introduced later

Note that the UCM/Heatmiser does not include Rs485 or Ethernet interface, and must be ordered separartely according to what heatmiser is used, RS485 or Ethernet

The UCM/Heatmiser manual can be downloaded from https://www.cytech.biz/ucmheatmiser_manu...ory_id=107

[ident]

UCM/Heatmiser firmware 7.033 has been released
The changes are

• \"Send Date/Time to Heatmiser\" under UCM/Heatmiser Properties is now working. This allows date and time to sync to Heatmiser
• Reading/writing for Frost Protect Temperature, Set Room Temperature and Thermostat are working
• Reading of Frost Protect Status, Built-in Temperature, Current Heating State, and Current Hot Water are working
  

[ident]

Heatmiser 7.034 (Beta) fixes some problems with Data error and conflicts for RS485 and wifi heatmisers

Those who have reported problems with heatmiser 7.033 please upgrade and test if the problems are fixed