+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Heatmiser (https://www.comfortforums.com/forum-42.html)
+--- Thread: Heatmiser 7.038 (/thread-3700.html)
- ident - 01-29-2014
The new firmware for Heatmiser, 7.038 has been released.
This fixes some problems in the earlier firmware, namely
- Overflow of buffer for RS485 to Comfort, resulting in lost info when there are several heatmisers on the network
- Fixed issues with Data Error caused by CRC
- UCM/Heatmiser for wifi heatmisers can coexist with the Multilink for smart phone control
- UCM/Heatmiser for RS485 can coexist with the Netmonitor
- Various improvements
Known Bugs
- Bug with Flag 1 mapped to heatmiser will not change the heatmiser setting
The UCM/Heatmiser for wifi requires the UCM/ETH03, see http://www.comfortforums.com/forum113/3695.html
ETH03-heatmiser 1.13 firmware is needed for the ethernet module. This firmware can be upgraded using Comfort Server Manager which is included inComfigurator 3.7.8
Please upgrade to the new firmware
The Heatmiser firmware can be upgraded by right clicking on the heatmiser UCM and selecting \"Check for Updates\" or downloading the firmware from https://www.cytech.biz/ucmheatmiser_firmware.html?category_id=101
and selecting \"Upgrade firmware from local file:
- slychiu - 02-03-2014
A bug in Heatmiser 7.038 has been found
If Flag 1 is mapped to any heatmiser setting, changing the Flag will not change the Heatmiser as expected
eg If Flag 1 is mapped to Thermostat on/off, then setting or clearing flag 1 will not affect the Thermostat on and off
This should be fixed soon. The workaround is to use another flag