+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Zwave (https://www.comfortforums.com/forum-62.html)
+--- Thread: Using VeraLite to associate with comfort virtual node (/thread-3993.html)
- lwillerton - 10-04-2014
Hi All,
I am trying to associate an everspring sp103 PIR with a comfort virtual node. My main controller is veralite which can see the virtual node or at leaste something of the same ID (I have called it virtual node by typing in manually) created by comfort, but it canââ¬â¢t populate the information the controller required to complete the setup, therefore vera states ââ¬Åfailed at: Getting manufacturerââ¬Â
Comfort info
z-wave properties
chip version 1
controller type bridge controller
module info 3.52
Has anybody managed to make an association to a virtual node with this config?
If so what is the process?
I have done this in the past with homeseers, aeon labs z-stick 2 and comfort.
Best Regards
Lee
- lwillerton - 10-04-2014
Pic2
- lwillerton - 10-04-2014
Pic3
- lwillerton - 10-04-2014
Pic4
- lwillerton - 10-04-2014
Pic 5
- lwillerton - 10-04-2014
To make the association in vera you go in to the device and setup a group id and the associate another device.
- lwillerton - 10-04-2014
Pic2
- lwillerton - 10-04-2014
If I try this I get a message failed to associate
- lwillerton - 10-04-2014
Pic3
- leonchue - 10-08-2014
\"but it canââ¬â¢t populate the information the controller required to complete the setup, therefore vera states ââ¬Åfailed at: Getting manufacturerââ¬Â\"
Maybe you should ask VeraLite what this problem is about.
Did you try associating physical devices with PIR also? Does it work?
What group ID (under Associations section) did you enter for PIR?