I\'ve just replaced my UCM 4.101 with a UCM 05 but find that it is not communicating intelligably with ACE server. Messages are being transmitted, but they don\'t seem to be read by ACE, which leads me to think that the format may be different. Is this so? The format expected by ACE is along the lines of C:IP-06-1 which would mean input change, zone 6, high.
The protocol has not changed from UCM01 to UCM05. The UCM05 may have additonal commands and messages but it should not affect teh communications with Ace
See if you can find out which messages are cauing the problem
I have now tracked down the messages which are problematic:
I am expecting the following messages from Comfort:
MD-1 security set to away mode
MD-0 Disarm
MD-4 Vacation mode
MD-2 Night mode.
Instead of these I am getting:
Night on Night off Away mode Away mode off Vacation on Vacation off SM000140 MD0001 SM000140 AM1301 SM000140 AM1301 SM000140 AM0881 SM000140 AL0A SM000000 AL0A SM000000 AL11 SM000000 KL02000000 SM000140 KL02000000 MD025A KL00010000 SM000000 KL02000000 SM000140 KL02000000 AM095A KL00010000 IP0201 SM000140 MD045A SM000140 AL13 SM000140 SM000140 MD0001 AM095A MD0001 KL0100 SM000000 SM000140 AM0881 AL13 AM0881 KL0100
IP0200 TO: AL11 KL0100 AL11 SM000140
I?01 SM000040 SM000000 SM000040 SM000000
I?0100 SM000040
SM000040
SM000000 KL00010000
KL00010000
SM000000 SM000140
SM000140
SM000140 SM000000 TO:
SM000000
MD015A I?01
AM095A I?0100
AL13
KL0100
SM000000
Are these responses documented anywhere? If so I should be able to write a script specifically for my needs.
I think I\'ve answered my own question now. I have found the serial interface protocol pdf, all I need to do now is change by expected responses to comply with that. I\'m assuming that the dash character is inserted by ACE, so I shouild be able to get around that.
