Wireless Sensor Interface to Comfort 1

[slayer91]

Hello,

I have a spare input zone on my Comfort 1 system, that I would like to use for a smoke or fire alarm. However, I have not ran any cabling to the sites where the fire/smoke sensors are best positioned. So I will have to use a wirless alarm, probably a Visionic.  Does anyone know of a wireless reciever that can be wired to Comforts zone input.

Regards

LiamK

Comfort Mark 1

 

[garym999]

Take a look at these. You could then use the output from the relay base to trigger Comfort. I\'m sure there are other systems out there too....