Comfigurator not updating time with UCM-ETH v.6.012

[Ingo]

I tested the exact same versions and mine works every time.

Ingo

[gaynorc]

Have you two UCM_ETHs connected, one old 5.092 and one new 6.012?

[Ingo]

Ok, I used 5.192 instead because I don\'t have a OTP version. I did your test from both UCM\'s and they both returned the correct time change. Before I forget, both my UCM\'s are ETH01\'s.

Ingo

[gaynorc]

Okay well the UCM_ETH v. 6.012 that I refer to is the ETH02 (silver)

[gaynorc]

Firstly:
I tried disconnect UCM 5.92 and did the date test again.
The date did not update.
UCM I/O monitor - same output as above.
It seemed to take, but did not.

HOWEVER:
The problem is wider than I thought. I cannot upload cclx files. It tries to start, waits, 0% progress, and then gives the error \"error writing configuration: no response from UCM\".

In summary on my UCM-ETH v6.012:
I can download the log file.
I can reset the system
I can get system information
I cannot update date and time
I cannot write PC->Comfort

[slychiu]

Were you able to write to Comfort before using the UCM/ETH 6.012 at all before? Or is this a new UCM that you have not used before. What were you using the UCM/ETH02 for before, was it for the iPhone app, and did that work with it?

can you send the screenshots of the DS Manager settings of the ETH02

[gaynorc]

Problem solved.

In October 2011 I updated the firmware on the Ethernet module (Tibbo Device) to the version suggested on the following link: http://www.comfortforums.com/forum96/2520-2.html

The purpose was to try and resolve iPhone ios5 connection problems. In that posting it was suggested as follows:

\"[Cytech] have not experienced this problem after upgrading to iOS5. This may be because we have been using a custom application on the EM500. This logs out the UCM when a connection has been lost for any reason. It also helps secure the system againts someone else connecting to the system after another connection has logged in. It allows a connection to connect only when the previous connection has logged out.\"

The firmware version was as follows: Attachment: cytech_application-3_02.zip (Downloaded 3 times)
See the discussion at: http://www.comfortforums.com/forum96/2520-2.html

Today I downloaded the version of firmware on your website: cytech_nowifi_3_10
Once I did that, the ETH worked fine.
(I hope!!)

[slychiu]

Thanks for that
I have deleted the old attachment from the link