Comfort 1 announcing tamper fault

[John W]

The main panel was fitted in 2001, which uses a microswitch and worjs fine.
the sep was fitted in 2009 and uses a round plastic plunger switch. It came with a spare switch, which I tested too and that acts the same.
no false alarms today so I am hoping that is it, fingers crossed !
I am now thinking it could be time to upgrade to a comfort 2 pcb. Is there a comfort 3 in the pipeline ? (If there is I will wait for it, I\'ve waited this long)

[admin]

There is always new versions in the pipeline no mater when you upgrade, but it would not be for another year or 2
If you have shorted the tamper then you should not have any tamper problems again

[John W]

Thanks. No tamper yesterday, yay !!
Fingers crossed it\'s fixed.

I\'m thinking of upgrading the pcb and Ethernet ucm so I can use the comfort apps, and get away from serial port for configurator.

If the main pcb is about to be revised then I would wait (eg I saw the discussion regarding dropping x10 in favour of Ethernet). I still use x10 for remote control of garden lights, so hope it doesn\'t get dropped...
I will send a message to determine cost and where to buy the upgrade should I decide to proceed.

Many thanks,
John.