Slave Firmware 7.141

[slychiu]

Bugs Fixes

1. Copy ID could not set ID to 5
2. Slave zone analog value was not correct Not affect 7.117
   
3. Strobe did not work on slave
4. Fixed Intermittent Communications Failure which may occur every day or every few days, applicable for Slave PCB hardware without Zone EOL shunts
   

[Swiss-Toni]

Could this be a cause of what was going on with SEM in topic http://www.comfortforums.com/forum91/4868.html

As i have been unable to resolve the issue (to be honest I gave up and move the pirs to zones 1 to 16)

[slychiu]

This should not be related to your problem which is zones becoming on and off when connected to the LEM

The issue with the SEM firmware is occasional Communications Failure
However there is no harm in upgrading to the latest SEM firmware to see if it makes any dofeerence