Posts: 6,024
Threads: 880
Joined: Apr 2006
Reputation:
3
It seems you may be trying to log in. Do Not Log in
Remember to Short PP2 shunt before trying
Go to Transfer > Firmware Upgrade using UCM Firmware cable
Then select the File
The upgrade will start
Posts: 106
Threads: 20
Joined: May 2010
Reputation:
0
double checked all cables and still getting same message. PP2 shunt is in place and i am not logging on. When i right click on the controller and do download firmware upgrade a message appears saying unable to obtain upgrade information.
Siren is going and keypads are beeping as per instructions.
Posts: 106
Threads: 20
Joined: May 2010
Reputation:
0
File 7.153 downloaded to PC but still getting message about UCM settings as previous
Posts: 6,024
Threads: 880
Joined: Apr 2006
Reputation:
3
This is an update on the problem reported.
UCM/ETH02 does not work when upgrading Firmware by right-Clicking on the module and selecting Upgrade. UCM/ETH02 was discontinued many years ago and does not support this newer function. This is why the initial Firmware upgrade did not work.
UCM/Eth02 can only do the upgrade by UCM Firmware Upgrade cable. This method managed to upgrade the ULT Firmware and get the system back to normal
Posts: 106
Threads: 20
Joined: May 2010
Reputation:
0
Changed to GSM4(3g) yesterday and working fine will change to ETH03 later today.
Posts: 106
Threads: 20
Joined: May 2010
Reputation:
0
Upgraded to ETH03. all went well and unit is getting IP address. When i scan for modules i get the message
---------------------------
Comfigurator
---------------------------
Failed to connect to UCM - please check the UCM Connection Settings
---------------------------
When i go back into the ETH03 it has the IP address and is at current software version.
Posts: 106
Threads: 20
Joined: May 2010
Reputation:
0
SORTED. Comfort not set to same IP Address as ETH03. Changed and all working as normal.
