KNX Support
Pages: 1 2
Important Threads
- Error writing to KNX (0 Replies)
- Bug in Comfigurator 3.11.0 to 3.11.1 (0 Replies)
- How to Send Date and Time to KNX (1 Reply)
- UCM/KNX Action Problem (1 Reply)
Threads
- UCM/KNX with C-Bus to KNX Translator (3 Replies)
- Counters (1-Bit) -> KNX (1 Reply)
- KNX Programming via Comfort (2 Replies)
- Bypass zone from KNX (1 Reply)
- UCM2 is not a UCM/KNX2 (5 Replies)
- Incomplete zone status to KNX (3 Replies)
- UCM/KNX in Monitor Mode (2 Replies)
- UCM/KNX race condition (4 Replies)
- KNX UCM (1 Reply)
- Upgrading UCM/Knx (1 Reply)
- KNX 1 bit switching map to Comfort Away Arm not working (2 Replies)
- UCM/KNX Monitor Mode (3 Replies)
- KNX Support Subforums (0 Replies)
- Communication KNX-Cytech problem (13 Replies)
- Sending Floating Point Type Telegram to KNX (0 Replies)
- KNX temperature readout in Comfort (11 Replies)
- spurious KNX packets from Comfort (16 Replies)
- UCM / KNX group adress limitations (6 Replies)
- Comfigurator Bug causes KNX Spurious Response (0 Replies)
- ETS configuration (1 Reply)
Pages: 1 2