Comfort Automation/ Security System Forums

I have a Comfort II with 2 UCMs, UCM01 is ethernet UCM02 z-wave.
Today I upgraded the Controller Firmware to 7.142.
I was also adding a KP06a keypad, it is woring.

All seem to be OK until I noticed in Comfigurator UCM02 not polled. I have now tested the z-wave comms and it is not working.
I have done a reset via comfigurator as well as poweringdown and back up again. Has not helped.
Any suggestions?

I just tried \'Read from EEPROM\' and get the message \'UCM 2 is not a UCM/Z-wave\'.

What leds are on or blinking in the UCM/Zwave UCM?

All the LEDs are on, no blinking.

It looks like the Zwave Firmware may be corruptedcan you try upgrading the UCM.Zwave firmware using the UCM Firmware Upgrade cable as inhttp://www.comfortforums.com/forum4/1782.html

I will try that. I am using firmware 7.104 you supplied for me. I assume that makes no difference.

No the firmware version should not have any effect

:-(
I went through the procedure and have an error \'DUT is not connected\'.

check if PP2 shunt is shorted, if it is there

It doesn\'t have a PP2.