Upgrade to firmware UCM Not Found

[Ian]

I have a Comfort II with 2 UCMs, UCM01 is ethernet UCM02 z-wave.
Today I upgraded the Controller Firmware to 7.142.
I was also adding a KP06a keypad, it is woring.

All seem to be OK until I noticed in Comfigurator UCM02 not polled. I have now tested the z-wave comms and it is not working.
I have done a reset via comfigurator as well as poweringdown and back up again. Has not helped.
Any suggestions?

[Ian]

I just tried \'Read from EEPROM\' and get the message \'UCM 2 is not a UCM/Z-wave\'.

[slychiu]

What leds are on or blinking in the UCM/Zwave UCM?

[Ian]

All the LEDs are on, no blinking.

[slychiu]

It looks like the Zwave Firmware may be corruptedcan you try upgrading the UCM.Zwave firmware using the UCM Firmware Upgrade cable as inhttp://www.comfortforums.com/forum4/1782.html

[Ian]

I will try that. I am using firmware 7.104 you supplied for me. I assume that makes no difference.

[slychiu]

No the firmware version should not have any effect

[Ian]

:-(
I went through the procedure and have an error \'DUT is not connected\'.

[slychiu]

check if PP2 shunt is shorted, if it is there

[Ian]

It doesn\'t have a PP2.