IRD01 Wiring

[engmoabel]

please confirm the IRD01 wiring terminal,

J2-is connected to any RIO input (RX).

J2- GND is connected to the COM of the same Rx input.

J1-LED is connected to an Output on the RIO( ex. the other block output which TX connected).

J1-TX is connected to an output on the RIO.

J1- 12v is connected to direct 12V on the RIO.

that wiring leave the COM pin at output block of (TX&LED) without wiring !!

Is that correct?

Thanks

[admin]

The Centre terminal of the Output terminal blocks are 12V so it is not necessary to connect it to the IRD as 12V is already connected between IRD and RIO