I wanted to use in double switches (I use MK Logic as the legacy switch) as the ACT ZWave switches I\'d used to date are generally single only. They do ACT 2 button but second button is for \"fly-by-wave\" association only and not directly switching the circuit.
I\'m not interested in dimming for these lights so used the 2x1.5KW switches from Fibraro. I haven\'t tried the dimming ones (they are singles) but that\'s next on my list.
I mounted these in 47mm deep single back boxes and even on one treble switch setup (2 internal lights switched by Fibraro relay, plus one switch for external PIR light) it all fitted OK (just) behind the switch and amongst the spaghetti of wires. I\'m using 3-wire (i.e. including neutral) and it works well.
No problems at all. If these had been around when I started I would have saved myself much of the pain I\'ve had with the ACT switches which are frankly cr*p in comparison. Shame as I\'m ã500 into investment in the ACT ones yet as cant justify ditching them for Fibraro replacements just yet.
I am just trying to set a fibaro 2 x 1.5w module up but am having trouble getting one of the switches to work.
I am using aeon labs z-stick 2 as my main controler and uploading this to comfort it has included a power switch binary which will only turn one light on and off.
It could be one of the Fibaro switch is not successfully included into the Aeon Labs Zwave network?
You should see all 3 devices (1 Aeon Labs + 2 Fibaro switches) inside Comfort\'s Z-wave Mapping tab.
Plus UCM/Zwave then you should be seeing 4 devices in total.
I have downloaded the homeseeres software demo and when I setup the aeon labs to work I can see both fibaro modules I have included and 2 switchs on each.
I can control the either module and both switches so 4 lights in total.
When I update the z-wave ucm in comfort it only pulls in one switch on each module.
Therefore, I can only assume that the problem is with comfort import.
