Fibaro Relays

[lwillerton]

Hi Hendy,

Please see HomeSeers imange

I have changed the name of the 2 switchs connected to fibaro 39 one is fire light the other is lounge LED, fibaro 44 I did not rename.

 

[juwi_uk]

Hi

Here are my Fibraro 2x1.5 switches (highlighted in yellow) after learn to comfort.

Regards

Julian

[juwi_uk]

I think the on/off test in Comfigurator only turns on/off Channel 1.

You can turn off other channel via response though as per normal operations.

J

[hendy]

Hi Lee,

are you turning on/off the switch through Comfigurator\'s Switch Device On/Off buttons?
If yes, then what Julian said is correct that the Zwave\'s on/off buttons in Comfigurator are for test purpose (to identify a node) and will only turn on/off first channel of a module.

[lwillerton]

Hi Hendy,

Yes I am turning on / off in the modules tab - ucm2 - z-wave mapping - on / off.

Do I need to control switch 2 on fibaro vai programming then?

Regards

Lee

[lwillerton]

Thank you so much Juwi / Hendy.

I will try to program later.

Best Regards

Lee

[lwillerton]

Hi,

Can I ask which primary controller you used? I have an aeon labs z-stick 2 and I only get a basic node.

If I use UCM fiware 6.23 I can control both switches but if I upgrade to the latest UCM firmware (7.xx) I am unable to control both Fibaro switches switch one is ok but switch 2 just doesn\'t work.

I am running my z-wave UCM at 6.23, but I am getting random on\'s from z-wave modules. I have looked at my code and can\'t seem much wrong so suspect its a z-wave network thing.

Any thoughts... Especially around the primary controller as I have just purchased 3 danfoss z-wave trv and want comfort to manage the temperature points

Best Regards

Lee

[juwi_uk]

I use the remotec ZRC-100 that Vesternet sell in the UK.

[lwillerton]

Great, I have just ordered one from vesternet £75.

Have you got any danfoss z-wave thermostates?

Cheers

Lee

[juwi_uk]

Nope. Boring old TRV\'s for me at the moment.

Next project is to rip out my old Smartfit boiler control (as my UCM/Smartfit is from the dark ages) and replace with the Heatmiser setup and new UCM/HM-Eth.

I just use ZWave for lights at the moment.