UCM/Zwave 7.061

[slychiu]

The new UCM/Zwave 7.061 beta allows Flags to be mapped to Zwave Virtual nodes
Please download from https://www.cytech.biz/ucmzwave_firmware.html

1. Flags can be used for mapping for Zwave nodes are 2 state ie either On or Off
2. Fixed a bug with Manufacturer query not supported
   

If the same flag is mapped to other devices eg Cbus, then it allows this mechanism to be used for sending commands from one system to another

Changing the state of the flag also changes the state of the mapped Zwave node, ie it is a 2 way control

Cmfigurator 3.9.5 (Beta) is required to support the new feature

[slychiu]

Zwave 7.061 firmware has now been released

Right click on the Zwave UCM and select \"Check for Updates\" to upgrade the firmwre

[juwi_uk]

Hi
Is there anything in this firmware that post upgrade would be causing my lights to go unstable. Ie they seem to be turning themselves on/off occasionally by themselves. Has been ok in period before I upgraded so trying to pin down.  All i have done is upgrade firmware but not done any read/writes etc to ucm so wondering if for example it needed that too?
Also on the latest UCM/eth3 and ULT firmwares too in case anything here.
I guess i should revert back to previous firmware and check if problems go away again? 
Julian 

[slychiu]

There should be nothing that causes your zwave to be randomely controlled

However you should look at the mapping to counters and flags  and do a write to eeprom

The new Zwave allows mapping to flags so there could be random information in eeprom locations that were not used before but may cause mappng to flags

So do a write to eeprom