ucm problem

[llebyat]

Hi

Am still having no luck getting a ucm to connect to comfort as per earler posts.

sw7 a,b,c are all shorted

sw8 has no jumpers on at all

j2 is in RS232

loc 1672 is set to 1

ready LED is on

D9/D10 are flashing correct

but following sig-in error message \"no response from UCM\" appears

ucm is connected to serial port com1

have tested com1 with other devices and all ok

Also

I have cs-xpress software and interface - when connected to com1 and you load the RS485 mointor you can see the tx and rx transmission. However if you download a .csx file it shows the transfer 0-100% and states its completed but following reset nothing has changed.

Am amiss as to what is wrong

all ucm settings appear correct and the comfort side seams ok - so it seams like its a pc problem - yet the port is working and the old cs-xpress software can talk to comfort yet wont over rite even though it states it has.

N.B i have both .csx and .ccl file formats

Any idea\'s please

David

[Guest]

Could it be a setting on Comfigurator? Check that the baud rate is set as \"9600\" and flow control set to \"none\".

[llebyat]

both those settings are correct?

[Guest]

[user=413]llebyat[/user] wrote:

both those settings are correct?

What is your Comfort firmware version?

[slychiu]

Adrian has replied to your post and is waiting for the result
In future I suggest you start a new  topic  instead of replying to a post by someone else as it causes confusion as you can see from this topic

regards

---UCM Ethernet Topic Moved---