Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
UCM/USB Firmware Upgrade from 7.110 fails
#1
Hi,

I’ve been trying to update the firmware in a UCM/USB module. 

It has 7.110 in it and is working with that. I have a comfort ultra II with firmware 8.013 and I am connecting in through a different UCM/ETH03 to do the upgrade with.

I’ve tried to upgrade to the latest 8.054 and 7.225 but when I do the module communicates with Comfort but not on the USB port. The FTDI drivers are correctly installed. What I noticed was

7.225 the ucm communicates with comfort but not directly on the usb port. The com port is missing in device manager until I press and hold down the reset button on the ucm. Whilst the reset button is pressed the device appears in device manager (both com port and serial converter entries). As soon as I let go of the reset button the device disappears.

8.054 the same as above happens however the error LED is also on. I read this is to do with the ucm thinking it has a WiFi module attached but it doesn’t. 

I reverted the firmware back to 7.110 and the ucm works again. Any help would be appreciated.

Jon
Reply

#2
Hi Jon
I assume your UCMs and Comfort are not the new ARM products.


did you do the firmware upgrade by right-clicking on the module and selecting Check for upgrades or Download fiormware upgrades and then Upgrade from local file. That ensures that the correct firmware is used for upgrade

If the ucms and comfort did not work after upgrade how did you manage to downgrade back to the olde firmware?

best rgds
chiu
Reply

#3
(Today, 01:09 AM)slychiu Wrote: Hi Jon
I assume your UCMs and Comfort are not the new ARM products.


did you do the firmware upgrade by right-clicking on the module and selecting Check for upgrades or Download fiormware upgrades and then Upgrade from local file. That ensures that the correct firmware is used for upgrade

If the ucms and comfort did not work after upgrade how did you manage to downgrade back to the olde firmware?

best rgds
chiu

Hi Chiu,

I trust you are well.

Both Comfort and UCMs are the older versions I.e. no arm processor. The main Comfort Firmware remained the same throughout this, I am connecting in to my comfort system using another UCM/ETH03 to upgrade the firmware in the UCM/USB.

Yes, I used right click to update the firmware but after it initially completed and I couldn’t see the com port in device manager and then found pressing and holding the reset button allowed it to be seen in device manager I down graded back to 7.10 to get it to work again.

Kind regards,
Jon
Reply



Forum Jump:


Users browsing this thread:
1 Guest(s)

Powered By MyBB, © 2002-2026 Melroy van den Berg.