Siren/Bellbox Connections to Comfort

[ident]

[user=4834]sppooky[/user] wrote:

TR- negative tamper return
V- negative supply
ST- negative strobe trigger
V+ positive supply
S- negative sounder trigger

TR- negative tamper return - to TAMP
V- negative supply - to COM
ST- negative strobe trigger - to STR-
V+ positive supply - to +12V
S- negative sounder trigger - to SRN-

[sppooky]

Hi thanks for the reply. When I opened the bell box the connections are slightly different to what was stated in the instructions. The 5 wired connections are

ST-
R-
SW-
V+
V-

Does R- go into tamp? What about SW-?

Cheers

[ident]

There must be some documentation to explain these labels otherwise you will have to do it by trial and error for R- and SW- for tamper and siren -ve

[wiredhome]

i would think

st- strobe trigger

r- tamper return

sw- siren trigger or tamper switch neg

ve+ pos bell hold

ve- neg bell hold off

scan and post the instructions from the sirenor a photo of the connections  and i can decipher them for you

[steefdebruijn]

Hi

Same question, different hardware. The aritech as271 has the following connections:

• Tamper (2 connections)
  12V
  Siren-
  Strobe-
  

How to connect to comfort?

I did the following, but cannot test yet because my house is not finished :-)

• Tamper: dedicated alarm input, must program as tamper alarm
  12V: srn+
  Siren-: srn-
  Strobe-: str-
  

But maybe the siren is a normal speaker and i should use the spk- and 12vf terminals...


Steef

[ident]

Your connection seem correct
Do not connect to the SPK terminals of Comfort. External bellboxes are not that way

[ninotorres]

Anyone has experience in connecting an EDS AS240 siren to Cytech?

The only documentation I have is the one in the following URL:

http://www.unitech.com.tr/upload/KLAVUZ/...40_Eng.pdf

Attached is a picture of the only connections I can see in the SIren. My bet is:

PCM SRN+ ---> SIREN \"+\"
PCM SRN- ---> SIREN \"-\"
PCM STR- ---> SIREN \"B\"

Comfigurator settings are at default on the siren related settings.

I don\'t get any sound on Siren. I can\'t even see the status leds in the Siren blinking.

The siren has a battery module that I can be sure if it is only for backup or for normal operations. Is it possible that the bateries are depleted?

Thanks,
Nino

[ident]

The photo does not match the connections on the manual
Photo has Tamp , + - B
Manual is SAB, +  - S
You should ask them for the correct manual

The + and - should be from Comfort12V and COM, NOT SRN+ and -
Assuming the B terminal  is siren trigger, this should be connected to SRN-