Wiring for wireless bell box

[gjb]

I am trying to connect a two-part wireless bell box (i.e. solar powered bell box + wireless transceiver).

The connections on the transceiver are as follows:

- Fault (open when in fault condition, e.g. low battery)
- Fault (as above)
- Tamper (positive return)
- Bell (negative trigger)
- Strobe (negative trigger)
- +12V
- Ground

Am I right in thinking this should be connected as follows?

Fault => Shorted to \'Ground\'
Fault => Z1
Tamper => TAMP
Bell => SRN-
Strobe => STR-
+12V => SRN+
Ground => COM

Also, what is the difference between 12V, 12VF and SRN+? Are they all permanent 12V feeds?

Thanks.

[ident]

It seems  correct
Tamper + should be in series with the case tamper if you are using that.

SRN+ is also 12V but has its own resettable fuse in case of a short circuit

The 12V at the centre of each output has a 300 ma resettable fuse to protect the outputs
I cannot find 12VF

S12V is a switched 12 V which can be controlled by actions

[gjb]

[user=86]ident[/user] wrote:

I cannot find 12VF

12VF is between SPK- and STR-

[ident]

Sorry about missing that 12VF is the middle pin between STR- and SPK-
This also has its own resettable fuse

[rubycrew]

Maybe this help you
http://www.teletechnika-system.pl/oferta...mputerowe/

[ident]

That link does not work, or is extremely slow

[rubycrew]

It cant be. I click on link and everything is working

[gjb]

Just to follow up on this. The wireless bell box is now installed, and the above wiring worked perfectly.

Thanks once again for your help ident