+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: Questions on Using Comfort (https://www.comfortforums.com/forum-159.html)
+--- Thread: View Camera through Comfort System (/thread-484.html)
- Patrick - 02-27-2007
May I know how can I view camera through Comfort System?
- ident - 02-27-2007
The CWM (http://www.comfortforums.com/forum49/279.html )
or the Companion touchscreens (http://www.comfortforums.com/forum35/45.html) allow IP cameras like Axis to be viewed
You cannot view cameras using Comfort alone
- on4cet - 02-28-2007
There are possibilities to watch camera\'s using comfort, if output from camera\'s is controlled by using eg. RLY01 or RLY02 relaisboards. The output can then be switched to a monitor, or time-lapse recorder etc...
I have a busch-wachter (PIR) on every side of the house (4), connected to a FINDER relay with 230Volt Coil, and 4 separate NC or NO contacts ...
1st contact for switching lights directly from the PIR
2nd contact for switching the Time-Lapse Recorder
3rd contact for switching the camera
4rd contact for switching an input of comfort to CLOSED state.
But, as said (and referred to in the manuals), this is a relais solution, by which you can view the source on a 3rd party device. Comfort is only involved for switching which camera you want to view !
Kind regards,
Bart
- ndh - 03-03-2007
Thanks Bart. Just related to this - There is a 4 camera switching application in the Application Manual on www.cytech.biz - it was written in the pre Comfigurator days.
Nigel
- gbsdvr - 07-03-2012
Visit http://www.gbsdvr.com/ for buying a good security camera.