View Camera through Comfort System

[Patrick]

May I know how can I view camera through Comfort System?

[ident]

The CWM (http://www.comfortforums.com/forum49/279.html )
or the Companion touchscreens (http://www.comfortforums.com/forum35/45.html) allow IP cameras like Axis to be viewed

You cannot view cameras using Comfort alone

[on4cet]

There are possibilities to watch camera\'s using comfort, if output from camera\'s is controlled by using eg. RLY01 or RLY02 relaisboards.  The output can then be switched to a monitor, or time-lapse recorder etc...

I have a busch-wachter (PIR) on every side of the house (4), connected to a FINDER relay with 230Volt Coil, and 4 separate NC or NO contacts ...

1st contact for switching lights directly from the PIR

2nd contact for switching the Time-Lapse Recorder

3rd contact for switching the camera

4rd contact for switching an input of comfort to CLOSED state.

 

But, as said (and referred to in the manuals), this is a relais solution, by which you can view the source on a 3rd party device.  Comfort is only involved for switching which camera you want to view !

 

Kind regards,

 

Bart

 

[ndh]

Thanks Bart. Just related to this - There is a 4 camera switching application in the Application Manual on www.cytech.biz  - it was written in the pre Comfigurator days.

Nigel

[gbsdvr]

Visit http://www.gbsdvr.com/ for buying a good security camera.